Kwikset REKYG KIT CP SMT KW Installation Guide download pdf

For Inswinging Door

For Outswinging Door

Inside

Outside

Inside

Outside

Left Hand Right Hand

PIN COVER UP

KEY CUTS UP

RETAINING

SPRING

01058-06

3. Insert cylinder removing tool (2) edgewise between screw stem (5) and

the detent slide (6) rotating tool clockwise to position shown. Apply slight

leverage to remove spring tension while holding spindle downwards

allowing spindle to drop out. If necessary use free thumb to assist removal.

If spindle rotates, repeat step 2.

4. Insert cylinder removing tool in lock housing (7) pushing together

cylinder retaining springs by moving tool up and down and push cylinder

out of knob. If door not available, note position of cylinder in knob for

reassembly.

5. Replace round spindle by lining up boss (3) with slot (4) and push

spindle until the detent spring snaps into place.

7. Position cylinder so that pin cover and key cuts are in the upward

position (as shown in illustration). Align cylinder with guides in knob and

insert, pressing until retaining springs snap into position.

2. Rotate Round Spindle (1) with cylinder removing tool (2) to line up

boss (3) with slot (4).

1. Remove key from Cylinder.

6. Install knob on door if door is available.

8. If key will not remove, begin again at step “A” and insure step ”E”

procedures are followed.

The hand of a door is always determined by facing the outside of a door.

If the hinge is on the left side of the door, then the door is left-handed.

If the hinge is on the right side of the door, then the door is right-handed

C. REMOVE CYLINDER

A. ALIGN SPINDLE

B. REMOVE SPINDLE

D. REPLACE SPINDLE

E. REPLACE CYLINDER

F. HOW TO DETERMINE HAND OF DOOR

Instructions for Removing and Replacing Cylinder of Entry Knob.

WARNING: This Manufacturer advises that no lock can provide complete security by itself. This lock may be defeated by forcible or technical means, or evaded by entry

elsewhere on the property. No lock can substitute for caution, awareness of your environment, and common sense. Builder’s hardware is available in multiple performance

grades to suit the application. In order to enhance security and reduce risk, you should consult a qualified locksmith or other security professional.

1 2

Summary of Contents

Page 1 - RETAINING

For Inswinging DoorFor Outswinging DoorInsideOutsideInsideOutsideLeft Hand Right Hand Left Hand Right Hand124372 5634PIN COVER UPKEY CUTS UPRETAININGS

Page 2 - BOTTOM PINS

A. REMOVE PLUG CLIP B. REMOVE PLUG C. REMOVE OLD PINS D. KEY MEASUREMENTE. FOR RANDOM KEYINGF. MASTER KEYING Kits 236 and 272 are capable of